Makita Nemesis II SDS-PLUS Hammer Drill Bit 6 x 115 mm 4-flute

The Makita Nemesis II SDS-PLUS drill bit, 6 × 115 mm, 4-flute, is a one-piece carbide SDS-PLUS bit designed for rotary hammers. It is intended primarily for hammer-drilling anchor and through-holes in structural materials, and works well across a range of dense substrates, from soft and hard concrete to natural stone. Reinforced concrete is handled straightforwardly, as the solid head keeps penetration steady when internal steel is encountered. The single-item pack contains exactly what is needed to replace a worn bit or to complete a specific 6 mm anchor installation.

The SDS-PLUS shank provides secure retention and direct compatibility with any standard rotary hammer that uses this system. The slotted drive end ensures reliable energy transfer without slipping in the chuck under high-load conditions. Operators can switch between standard rotary drilling and hammer-drilling mode depending on the material. This dual-mode capability lets the bit adapt to varying densities within a single masonry element. It is exclusively a power-tool accessory and requires a matching SDS chuck for safe use.

• 50 mm working length gives a controlled depth limit for setting typical masonry anchors and fixings.
• Four independent cutting edges share the load, improving hole concentricity in rough materials.
• One-piece cutting head removes weak points at the tip junction for consistent high-impact durability.
• 4-flute spiral geometry channels debris out continuously, maintaining hole quality during deep penetration.
• Integrated centring tip reduces bit wandering and ensures a straight start on smooth concrete surfaces.